The users guide was excellent. It provided the information neeeded to connect and control the Crate system. Nothing was left to chance
Text excerpt from page 300 (click to view)
Appendix B Control Panel Menus Item RAM DISK=OFF Values OFF ON AUTO Explanation This item determines how the RAM disk is configured. This item appears only if there is no optional hard disk installed and the printer has at least 12 MB of memory. OFF: The RAM disk is disabled. ON: The RAM disk is enabled. Configure the amount of memory to be used through the following item: RAM DISK SIZE. Note If the setting is changed from OFF to ON or from OFF to AUTO, the printer will automatically reinitialize when it becomes idle. This item determines the size of the RAM disk. This item appears if RAM DISK=ON or AUTO. Press - VALUE + to change settings by increments of 100. Note This setting cannot be changed if RAM DISK=AUTO. Changing this value will cause the printer to reinitialize when it becomes idle.
300
RAM DISK SIZE=xxxK
0K and up (This value depends on the amount of installed memory.)
